1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 162Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 162

f13l 13Remove the rod caps from connecting rodsPlace one retainer half and bearings on each rod 1141 14Place crankshaft in
lead, determine if the caps are aligned properly by scraping it across the joint between the cap and the rodIf your rod caps
are not correctly aligned, lightly tap them into position with an aluminum rod and malletReplace connecting rod assembly
if satisfactory cap and rod alignment cannot be achieved1,8l 18Tighten the screws in stages to final torque of 60-70 inIbs(7,0-7,5
Nm) L!2J they were originally, and then using your fingernail or pencil 17Install both rod caps finger tight exactly positioned