1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 164Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 164

28Oil and place new O-ring on the crankcase headInstall the crankcase headApply OMC Gasket Sealing Compound to threads of
34Apply OMC Gasket Sealing Compound to both sides of two new exhaust cover gasketsInstall the inner and outer exhaust coversTighten
the screws to torque of 95-130 inIbs(11-14 Nm), starting with the center screwsr:;; 35Apply OMC Gasket Sealing Compound to
both sides of new bypass cover gasketInstall the bypass coverInstall and tighten the screws to torque of 60-84 inIbs(7-9
Nm), starting with the center screws 1 29136Install the intake manifold and leaf valve assembly using new gasketsDo not use
sealer on these gasketsTighten the screws to torque of 60-84 inIbs(7-9 Nm)37Install the carburetion, ignition, and electrical
components to the powerhead ill cover, make sure ignition and electrical wires are routed '" To prevent possible fire and
explosion under the engine and clamped in original position; away from rotating parts which could cut or abrade wire insulation