1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 165Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 165

Installation Remove the gearcase as described in Section 6This will aid in guiding the water tube into the water pump grom-
Guide the small water tube into the opening in the rear of the exhaust housing Apply OMC Gasket Sealing Compound to the six
powerhead retaining screws and install the screwsTighten the six powerhead retaining screws to torque of 60-84 inIbs(7-9
Nm)&5Adjust the neutral start switch To avoid permanent powerhead damage, instruct operator to repeat the original engine
break-in procedure as described in Section before putting engine back into normal service Neutral Start Switch AdjustmentTiller
Electric 9.915 INotel Disconnect the battery cables at the battery f1l 1To test, shift motor into NEUTRALDisconnect the starter
motor red wire at the motor f1l 2Attach continuity light or ohmmeter between the starter wire and the neutral start switch