1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 179Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 179

1251 12 Using tool as drawn on Page 4-9, or equivalent, push the taper pin toward the intake manifold surfaceDo not use any
and keep the needles of each cylinder togetherr==lN Loosely install cylinder head to prevent pistons from falling 1291 16Remove
the rod cap screws using OMC Torque Socket, PIN 331638Remove the cap's needle bearings and cages130 17Lift the crankshaft
out of the cylinder blockReplace the rod caps on the rodsOrient them exactly as they were before you removed themInstall
the screws finger tightra1l 18Rotate the powerhead so that the cylinder head faces upRemove the cylinder head and gently
push up on the connecting rods to remove No1 and No2 piston assembliesProtect the condition of the piston by packing paper
towels between the connecting rod and pistonDo not allow the connecting rod to contact the inside of the piston skirt during