1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 184Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 184

r;;l12Use feeler gauge to check groove side clearance on the lower square ringsInstall each square ring on its pistonWith
forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricantf1l1Lightly
lubricate the three water deflectors with STP Oil TreatmentInstall the two long and one short water deflectors until they
are flush, or nearly flush, with the gasket surface DO NOT shorten the water deflectorsThe water deflectors might be slightly
above the gasket surface in normal installationf212Determine which part of the piston faces up by holding the piston next
to the cylinder blockWhen installed, the sharp edge of the piston deflector will face the intake portsr:;J 3Apply OMC Needle
Bearing Assembly Grease to the 28 wrist pin bearingsInstall the bearings in the wrist pin boreAlign the bearings in the bore