1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 185Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 185

5The connecting rod has no specific orientationSupport the piston in OMC Piston Cradle, PIN 326573Oil the wrist pin bore
with OMC Triple-Guard grease11 To install new lower main bearing: Oil the end of the crankshaftUse OMC Crankshaft Bearingl
Sleeve Installer, PIN 339749, and place bearing onto crankshaft with lettered side facing the toolInstall bearing until it
seats in the crankshaft1111 12To install new crankshaft sleeve: Oil the end of the crankshaftPlace the sleeve in OMC Crankshaft
Bearingl Sleeve, PIN 339749, and drive the sleeve onto the crankshaft until the installer contacts the lower main bearing
If the installer sticks on the sleeve after installation, thread OMC Slide Hammer, PI 391008, onto installer and pull off
Inspect sleeve surface after installing Sleeve must not be used if surface is damaged 1,2l 13Lubricate new driveshaft a-ring
and lightly lubricate crankshaft splines with OMC Moly LubeInstall -ring in sleevef131 14Using retaining ring pliers, install