1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 189Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 189

34Thoroughly clean and degrease the crankcase mating flange of the cylinder block with OMC Cleaning Solvent and let air dry35Apply
between the crankshaft and the bearings on the connecting rods by rotating the crankshaft with the flywheel1301 42Lightly
coat the machined mating surface of the crankcase head with OMC Gasket Sealing CompoundLubricate new crankcase head O-ring
with OMC Triple-Guard grease and install itInstall the lower crankcase headLightly coat the threads of three new crankcase
head screws with OMC Gasket Sealing Compound and install them finger tightrJ1l 43Starting with the center screws, tighten
the six main bearing screws to torque of 168-192 inIbs(19-22 Nm)Starting with the center screws, tighten the remaining eight
screws to torque of 60-84 inIbs(7-9 Nm)44Tighten the three lower crankcase head screws to torque of 60-84 inIbs(7-9 Nm)45Apply
OMC Gasket Sealing Compound to outside metal casing of new upper main bearing sealUsing OMC Seal Installer, PIN 321539, install
the seal with its lip facing down32 46Lightly coat both sides of new cylinder head gasket with OMC Gasket Sealing CompoundInstall