1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 191Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 191

Installation head with OMC Triple-Guard greaseInstall the a-ring in groove of the crankcase head Gl 1Lightly coat new a-ring
retaining screws to of 192-216 inIbs(22-24 Nm)6Apply OMC Nut Lock to the threads of the port and starboard exhaust housing
studsPlace the washer on the studsInstall and tighten the two powerhead retaining nutsf4l 7Install the ground lead to the
powerheadApply OMC Black Neoprene Dip to ground screw connections8Install the carburetor, ignition, and electrical components
to the powerhead i and ignition wiring is routed and clamped in its original position "'" To prevent possible fire or explosion,
make sure all electrical r;;J 9Rand TE ModelsInstall the neutral start plunger and spring through the component bracketUsing
pinsecure the plunger as shown pivot screwand flat washeras shownTighten the pivot screw to torque of 60-84 inIbs(7-9 Nm)