1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 193Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 193

Shift Lever Adjustment, 20 thru 30 1Rotate the propeller shaft and move the shift lever to NEUTRAL [TI 2Loosen both shift
the two neutral start switch screws Insert V16 in(1,6 mm) drill bit between the bottom of the switch and the top of the plunger
Move the switch until the switch and plunger contact the drill bit Tighten the switch screws securely4To test for proper
operation of the neutral start switch, connect continuity light or an ohmmeter (set to low ohms scale) between the neutral
start switch yellowred lead terminal and ground With the motor in NEUTRAL, the light or ohmmeter should show continuity While
rotating the propeller shaft, shift the motor into FORWARD, then REVERSEThe light or ohmmeter should not show continuity
in either FORWARD or REVERSE5If adjustment is necessary, rotate the propeller shaft and shift motor into NEUTRALLoosen the