1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 215Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 215

Installation 1Insert the stop button leads and the throttle cable through the lower engine cover grommet2Apply OMC Triple-Guard
Nm)rJl6Using OMC Insert Tool, PIN 322697, install the stop button lead into the plugConnect the 1-pin Amphenol connectorSecure
connector with wire retainer1017Thread the connector onto the cable housing 1314 in (44 mm) from end of the cable sleeveSecure
connector in place with nut8Thread the bracket onto the cable until seatedr:;J 9Position the connector on the throttle armSecure
the connector to the throttle arm using two washers and cotter pinf1l10Secure the bracket to the lower engine cover using