1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 220Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 220

1sl 8Remove the three screws retaining the idle relief mufflerRemove the mufflerDiscard the muffler gasket and seals from
housing that retain both lower side mounts to the exhaust housing15Refer to Cleaning and Inspection at the beginning of this
sectionAssembly and Installation If not otherwise specified, apply OMC Gasket Sealing Compound threads of all screwsf1Ol
1Apply OMC Gasket Sealing Compound to the threads of lower side mountsInstall the two lower side mounts Tighten the nuts
to torque of 144-168 in Ibs(16-19 Nm) f10l f11l 2 Install the lower front and the upper side mounts to the exhaust housmg
1.j3l 3Install the lower motor cover bracket to the exhaust housingApply OMC Adhesive to the seal surface of the exhaust
housingPosition new exhaust housing to lower engine cover seal the upper side mountsPlace front of the exhaust housing over
the upper front mountPush lower part of the exhaust housing toward the swivel bracketAlign the two upper side mounts in the