1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 221Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 221

rgJ r,()l5Slide the mount housing bumper into place between the lower front mount and the exhaust housingPosition the port
Q) into placePlace new shift rod lever clip over the shift rod leverInstall and tighten the screw to torque of 60-84 inIbs(7-9
Nm).Bend the locking tab of the clip against the head of the screw r;5l8If removed, apply OMC Adhesive to the four washers
and place the washers as shown in figurePlace the lower engine cover on the exhaust housingInstall and tighten the screws
to torque of 72-96 inIbs(8-11 Nm) 11619Slide the actuator cam through the lower engine cover Place the bottom of the cam
over the grease fitting of the adjustment lever and shaftPosition the actuator cam grommet in place in the lower engine cover
r:r7l10Remote ModelsSecure the shift lever to the adjustment lever and shaft with two screws and lock washers11 Install the