1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 241Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 241

16Remove the shift rod bushing as follows: Position OMC Shift Rod Bushing Remover, PIN 327693, under the shift rod bushing
and discard the a-ring from the bushing13 r:;-;J 17Using OMC Puller Bridge, PIN 432127, and OMC Small Puller Jaws, PIN 432131,
remove the two driveshaft sealsDiscard the seals r::=J Inspect bearings for damage while in placeIf bearing is damaged, remove
and discardIfthe bearing is removed for any reason, it must be replacedf15118Using OMC Puller Bridge, PIN 432127, and OMC
Small Puller Jaws, PIN 432131, remove the bearing and sleeve from the gearcaseDiscard the bearing19Using OMC Slide Hammer,