1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 244Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 244

Assembly Make no dry assembliesLubricate bearings, shafts, and gear with OMC Ultra-HPF gearcase lube rv bearingthe small
the seals into the housing until the tool is seatedApply OMC Triple-Guard grease to the seal lips after installing4Apply
OMC Triple-Guard grease to new bearing housing a-ringPlace the a-ring in the bearing housing groove32551 f4l 5To install
the forward bearing cup into the gearcase, remove the gearcase from the holding fixture, and place the nose of it on wooden
blockDrive in the bearing cup with mallet and OMC Bearing Cup Installer, PIN 319929, attached to OMC Drive Handle, PIN 3118801sl
6Install the pinion bearings using the following components of OMC Universal Pinion Bearing Remover and Installer, PIN 391257,
and one additional tool spacer: 326582 Rod 326583 Plate 326578 Removerllnstaller -20 V2 inScrew -20 inScrew inFlat Washer