1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 246Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 246

r:J2l14Position one pinion thrust washer on the pinionOil and install the thrust bearing Install the other thrust washer
yoke until seatedThen back out shift rod until slotted face of connector faces the driveshaft f17l19Using long-nose pliers,
place the clutch dog in the cradle with grooved side facing the forward gearINote Groove on the clutch dog must face the
forward gear20Apply OMC Needle Bearing Assembly Grease to the propeller shaft spring and two detent ballsInstall the spring
and balls in the propeller shaftAlign the two detent balls with the two grooves in internal splines of the clutch dog21Aid
installation of loose detent ball with flat blade screwdriverPush the propeller shaft into the clutch dog, forward gear and
the forward bearing22Hold propeller shaft in place and move shift rod up to NEUTRAL position23Slide the reverse gear onto