1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 248Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 248

Installation 1On models with gearcase extension kit make sure the driveshaft tube extension, water tube extension, and gearcase
the groove in the lower shift rod with the screw hole When installing gearcase to gearcase extension, do not tighten the
retaining screws until the gearcase and the extension have been placed in proper position with the exhaust housing and powerhead
assemblyf316Apply OMC Gasket Sealing Compound to the threads of the gearcase and extension retaining screwsInstall and tighten
the screws to torque of 96-120 inIbs(11-14 Nm)Install the propeller as follows: Apply OMC Triple-Guard grease to entire length
of the propeller shaft Install the thrust bushing onto the propeller shaft with shoulder of the bushing facing aft and fish
line trap groove facing forward Install the propellerPropeller should seat onto the thrust bushing Install the spacerengaging
the propeller shaft splines Install and tighten the propeller nut to torque of 120 in.lbs14 Nm).Continuetotightenthenuttoalign