1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 261Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 261

3Coat the driveshaft splines with OMC Moly LubeDo not coat top surface of the driveshaft as the lubricant here may prevent
in proper position with the exhaust housing and powerhead assembly 1601 7Slide the upper connector half onto the upper shift
rod and install the plastic keeper rsv 8Move therod connectorWhileupper shift rod engages rod shift lever until the the lower
shift holding the lower shift connector, tighten the upper shift rod connector securely162 9Install the port and starboard
water intake screens with water intake holes facing rear of gearcaseTighten the two screen retaining screws securely 1631
10Install the propeller as follows: Apply OMC Triple-Guard grease to entire length of the propeller shaft Install the large
thrust bushing onto the propeller shaft with fish line groove facing gearcase Install the propellerPropeller should seat
onto the thrust bushing Install the spacer splines engaging the propeller shaft Install the propeller nut CD to torque of