1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 269Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 269

Assembly Make no dry assembliesLubricate bearings, shafts, and gears with OMC Ultra-HPF gearcase lube1Coat the shift rod
casing of the seals before installingInstall the inner seal with lip facing toward the gearcase and the outer seal with lip
facing away from the gearcaseApply OMC Triple-Guard grease to the seal lips after installing 12514Install two new upper driveshaft
seals back to back in the 12615Oil, then install new pinion bearing in the gearcase using OMC Pinion Bearing Installer, PIN
326565Press against the lettered side of the bearing until the tool is seated on the gearcase 127112816Install new seals
back to back in the gearcase head using OMC Seal Installer, PIN 326691Apply OMC Gasket Sealing Compound to the metal casing
of the seals before installingInstall the inner seal with lip facing in the gearcase head and the outer seal with lip facing