1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 271Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 271

1351 14Place bead of OMC Adhesive on the upper gearcase in the location shown1361 15Position the propeller shaft assembly
the seal for length of 1f2 in (12 mm) 19Position the lower gearcase on the upper gearcaseApply OMC Gasket Sealing Compound
to the threads of the gearcase retaining screwsInstall the two front and two rear screws, then loosely tighten the screws
evenly to draw the gearcases togetherPush rearward on the lower gearcase with steady pressure as the retaining screws are
tightened Install the remaining screws and gradually tighten them, alternating from side to side and working toward the rearTighten
the screws to torque of 60-80 in Ibs(7-9 Nm)Remove the alignment tool 39 20Apply OMC Tripe-Guardgrease to new pivot pin a-ring
Install the -ring on the pivot pinApply OMC Nut Lockto the threads of the pinInstall the pivot pinYou may have to move the