1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 272Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 272

1401 21Carefully slide the driveshaft into positionRotate the driveshaft until it engages the pinion ] 22Pressure and vacuum
testerPump out 3-5 in (76-127 mm) of mercury and see if vacuum holdsThen pump out 15 in(381 mm) of mercury and checkIf the
gearcase fails to hold on either test, put lubricant around suspected sealIf the leak then stops or lubricant is drawn in,
the seal is defectiveWhen the gearcase checks out properly, fill the gearcase with OMC Ultra-HPF gearcase lubricant23Fill
the gearcase with lubricant as follows: Be sure the gearcase is in an upright position Remove the oil level and oil filldrain
plugsReplace the seals if damaged Fill the gearcase with OMC Ultra-HPFgearcase lube until lubricant appears at the oil level
holeInsert the oil level plug firstInstall the fill drain plugTighten the oil level and fill drain plugs to torque of 84-86