1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 279Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 279

Cleaning and Inspection 1Wash metal components in solvent and dry with compressed air2Inspect the rewind spring for cracked
because of rewind spring tension Wear safety glasses while disassembling and assembling EI shield, spring, and pulley bearing
surfaces with OMC TripleGuard greasef912Insert spring through starter housingHook spring end into pulley hub slot as pulley
is placed in position in the starter housingr,Ql3Hold pulley in place and turn pulley slightly to check that spring is hooked
to pulleySecure pulley with screw, lubricated spindle, and locknutTorque locknut to 120-140 inIbs(14-16 Nm) 1sl1Place shield
into starter housingLubricate starter housing, r,v 4With starter upside down, carefully turn pulley counter- clockwise until