1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 283Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 283

Assembly Wear safety glasses while disassembling and assembling manual starters because of rewind spring tension f71 1Using
the direction shown on the toolWind the spring into the starter winder base until end of rewind spring contacts the starter
winder base Remove the crank retainer screw and the crank and pin assembly from the starter winder base 5Remove the adapter
release plate with the rewind spring from the starter winder base Place the solid starter spring shield into the starter
housmg f121 7Install the rewind spring into the starter housing Locate the outer loop of the rewind spring on the pin in
the starter housingPress down through the holes of the adapter release plate to transfer the rewind spring into the starter