1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 284Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 284

f14l 9Bend the inside loop ofthe rewind spring in toward the center of the starter housingEngage the pin (B) of the pulley
of the nutHold the spindle screw and torque the nut to 120-145 inIbs(14-16 Nm)f161 13Tie knot in one end of the starter ropeWith
the starter housing upside down on bench, wind the pulley counterclockwise until the rewind spring is tightBack off the spring
about 12 to turnThread the starter rope through the hole in the pulley, behind roll pin in pulley, and out through the starter
housing1171 14Apply OMC Triple-Guard grease or Lubriplate 777 to the handle end of the starter ropeUsing OMC Starter Rope
Threading Tool PIN 378774, thread the starter rope through the handlePress the starter rope into the channel of the rope
anchor, with end of starter rope butting firmly against end of channelPress the anchor into the handleTug on end of starter
rope to seat the knot against the pulleyAllow the starter rope to wind slowly onto the pulley15Check the operation of the
pawls when the starter rope is pulled outThe pawls should extend when the starter rope is pulled and retract when the starter