1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 305Get this manual

1994 Johnson/Evinrude "ER" 9.9 thru 30 outboards Service Manual, Page 305

Assembly 1Lubricate the armature shaft bearing surface with one drop of SAE No10 oilLubricate the armature shaft on and above
drop of oil on the two thru-bolts and install the ill thru-boltsTighten the thru-bolts to torque of 30-40 inIbs (3,4-4,6
Nm)Apply OMC Black Neoprene Dip to the seams between the end caps and frame and magnet assemblyL!!J ture shaftTighten the
nutto torque of 150-170 inlbs(17-19 Nm) 101 7Assemble the pinion, spring, spacer, and nut to the arma- 8Refer to No Load
Current Draw, Electric Starter to check starter operationInstallation LJ motor must be held firmly against the bracket while
bolting it to the bypass coverTighten screws to torque of 10-12 ftIbs(14-16 Nm) 191 1Install the starter on the bypass coverThe
electric starter 191 Install the LJ securelystarter lead to the starterTighten the nut Apply OMC Black Neoprene Dip to connection
Then, tightening the terminal nut, make sure the starter lead and terminal does not turn into position where the lead and