1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 69Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 69

Remote Control Cable InstallationEngine ill cables are disconnected at batteryControl Identification I:ATo prevent accidental
anchor block pockets f21 2Extend throttle cable and lubricate with OMC Triple-Guard 3Verify that the fast idle lever is down
in the RUN position4While rotating the propeller shaft, move the remote control handle from NEUTRAL to the FORWARD detent
and then halfway back to NEUTRALThis positions the control for proper throttle cable adjustmentFailure to follow this procedure
exactly might cause accel erated wear of shift system components and high shifting effort 5Move engine throttle lever tightly
against idle stop screw 6Attach cable casing guide to throttle lever pin using locknut and washer supplied with engineTighten
locknut securely t:!J trunnion nut in anchor pocket 7Pull firmly on throttle cable to remove backlash and install 1sl 8Install
cable retainer and torque screw to 60-84 inIbs(7-9 9Check cable adjustment; if throttle cable adjustment is too loose, idle