1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 70Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 70

Shift Cable 1Extend shift cable and lubricate with OMC Triple-Guard grease2Verify that the fast idle lever is down in the
cable to allow the adjustment in Step 7, or if the gearcase detent does not correspond with remote control NEUTRAL in Step
10, refer to Section for shift rod height adjustment i and washer supplied with engineTighten locknut 11Attach shift cable
to shift lever pin using locknut securely rt:i=l When installing OMC Accessory Controls, except for prewired surface mount,
the shift cable must be adjusted and installed when the control and engine are in NEUTRAL12Slip rubber grommet onto control
cables and press grommet into groove in lower engine cover i attached to the proper engine levers by lifting the fast idle
lever to the START positionIf correctly attached, the throttle cable and engine throttle lever will move 13Inspect installation
to ensure that the control cables are rt:i=l When installing remote control that is not manufactured by Outboard Marine Corporation,