1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 208Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 208

Assembly Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly
side facing the toolInstall bearing until it seats in the crankshaftr:;J 4V4, V6To install new crankshaft sleeve: Oil the
end of the crankshaftPlace the sleeve in OMC Crankshaft Bearingl Sleeve Installer, PIN 338649, and drive the sleeve onto
the crankshaft until the installer contacts the lower main bearing If the installer sticks on the sleeve after installation,
thread OMC Slide Hammer, PIN 391008, into installer and pull offf41 5 Inspect sleeve surface after installingSleeve must
not be used if surface is damaged V4, V6Lubricate new driveshaft a-ring and lightly lubricate crankshaft splines with OMC
Moly LubeInstall O-ring in sleeve r;'] 6V8To install new lower main bearing: Oi the end of the crankshaftPlace bearing on