1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 211Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 211

22When all pistons and connecting rods are assembled, install piston ring setsInstall each piston ring set on the piston
and locate piston rings on their dowel pinsSlide No2 piston assembly into top cylinder, as shown, while guiding connecting
rod through cylinder block26Repeat Steps 24 and 25 for remaining piston(s) on the port side27Lightly coat both sides of new
cylinder head gasket with OMC Gasket Sealing CompoundInstall gasket with the tab facing up1231 28Install port cylinder head,
thermostat facing flywheel, and install retaining screwsFollowing sequence on cylinder head, torque all screws in stages
to: 18-20 ftIbs(24-27 Nm) V615-17 ftIbs(20-23 Nm) 29Rotate cylinder block so that starboard cylinder head surface is parallel
with floor30Repeat Steps 24 and 25 for the starboard cylinders31Rotate cylinder block so that crankcase mating flange is
facing up32Push all pistons to top dead centerRemove numbered connecting rod caps and hold rods to the outside with rubber