1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 216Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 216

Installation Install new base gasketwithout sealerThe gasket has coating which is heat activated and must be assembled dryTo
144-168 inIbs(16-19 Nm)In order to achieve proper sealing and prevent gasket damage, the powerhead mounting screws must be
retorqued after engine has reached operating temperature and has been allowed to cool f41 6Torque the two screws and one
nut, powerhead to exhaust adaptor, to 144-168 inIbs(16-19 Nm) 7If equipped with power steering, install the systemApply OMC
Nut Lock to threads of reservoir-to-cylinder-block screwsTorque the reservoir-to-cylinder-block screws to 18-20 ftIbs(25-27
Nm)Route all hoses and secure in their original locations8Thoroughly clean the crankshaft and flywheel tapers with OMC Cleaning
Solvent and let air dry9Install flywheel key in crankshaft with flat side parallel to crankshaft centerline [';1 10Align