1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 275Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 275

rJl 5up the water tube grommet with the inside taper 6Install the impeller housing cover (0f81 7Apply OMC Adhesive sealant
Grease to flat area of the driveshaftInstall the drive camThe sharp edge of the cam is the leading edge during driveshaft
rotation 4Slide the water pump assembly down the driveshaftAlign slot in the impeller with the impeller camRotate the driveshaft
to engage the impeller cam with the impeller, and slide water pump assembly down over impellerBe sure impeller cam does not
fall out of positionVerify that the impeller engages the impeller cam properlySerious powerhead damage will result if impeller
cam is displaced5Align the impeller housing with the gearcaseApply OMC Gasket Sealing Compound to threads of the four impeller
screwsInstall the screws and tighten to torque of 60-84 inIbs(7-9 Nm)r:J1'l 6If equipped, place water tube spacer with grommet