1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 281Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 281

5V4If equipped, remove the two retaining rings using Ring Pliers, PIN 331045Retaining rings are under extreme pressure during
by using OMC Driveshaft Holding Socket, PIN 311875 Q), and OMC Pinion Holder, PIN 334455 Pad the handle of the holder to
prevent damage to the gearcase G1l f12l 11Pull up on the driveshaft to remove it from the gearcaseThe driveshaft to pinion
taper is locking taperIf necessary, use OMC Puller, PIN 390706 CD, and OMC Backing Plate, PIN 325867to break the lockInstall
the tools, as shown, by clamping them around the driveshaft with the tool's set screw aligned with the water pump drive cam
slotThen, tighten the set screw into the slotAlternately tighten the two vertical screws against the backing plate inserted
between the puller and the gearcase until the driveshaft pops loose from the pinion, then remove the tools f131 12The bearing
housingshimsthrust bearing thrust washer will come out with the driveshaft 13Reach inside the gearcaseRemove the pinion and