1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 284Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 284

25V4Remove the water intake screen by depressing the tabs and pushing upwardInspect the screen for blockagePropeller Shaft
and dry thoroughlyIf bearings were not replaced, rotate the needles with your fingers to check for freedom of movementInspect
a-ring groove; sand off any sharp edges that would cut a-ring and prevent its sealingV4Thoroughly clean the threads of the
four bearing housing retaining screwsDiscard the retaining screws' seals f31 4Inspect the bearing housing anodeReplace anode
if it has eroded to two-thirds its original size5Oil, then install new bearings in the bearing housing V4use OMC Bearing
Installer, PI 326562, to install the forward bearing and rear bearing V6use OMC Bearing Installer, PIN 339750, to install
the forward bearing and rear bearing Place the lettered end ofthe bearing case on the bearing installer, then press the bearing