1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 285Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 285

6 DR2061 DR2062 COA3559 6Install two new seals back to back in the rear of the bearing housing V4use OMC Seal Installer,
housing seals using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PI 432129Discard the seals2Remove the a-ring
from the bearing housing and discard 3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring
groove1sl 4Install new seals back to back in the bearing housing using OMC Seal Installer, PIN 330268Apply OMC Gasket Sealing
Compound to the metal casings of the seals before installingInstall the inner seal with flush lip facing toward the bearing
housing, then the outer seal with extended lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal
lips after installing14156 19l Lightly apply OMC Triple-Guard grease to new a-ring Install the a-ring in top groove of the
bearing housing Do not install the a-ring in the bearing housing's bottom grooveThe bottom groove is an oil passageGearcase