1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 287Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 287

2Select the correct gauge and collar: V4OMC Gauge, PI 328366, and OMC Collar, PI 328362 V6OMC Gauge, PIN 328367, and OMC
of the pinion to the driveshaft by holding the gauge bar against the bearing housing (between the screw holes) while rotating
just the driveshaft and pinion assembly and measuring the clearance between the gauge bar and the pinionReplace the pinion
or the driveshaft, as necessary, and repeat the check if variance exceeds 0.002 in (0,050 mm)9Subtract the average clearance
measurement you obtained in Step from 0.020 in(0,508 mm) to determine the correct shim thickness requiredSelect the fewest
number of shims to achieve the correct thickness10Remove the driveshaft from the tool baseRemove the collar and bearing housing
from the driveshaft, and add the required amount of shimsUse extreme care when removing bearing housing to avoid damaging
the sealsUse OMC Driveshaft Seal Protector, PIN 31867411Check shimming by reassembling the driveshaft with shims and placing
it back into the tool baseThe measurement between the gauge bar and the pinion should be 0.020 in(0,508 mm) 12Remove the