1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 289Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 289

7Lightly coat the detent ball and spring with OMC Needle Bearing Assembly GreaseFirst, insert the spring in the housing,
toward the housing, then reach inside and attach it to the detent leverAlign the pivot holes and insert the retaining pin
1sl 11Push the detent lever down to its most depressed positionRest the cradle on the shift shaft (f)then attach the cradle
and shaft to the wide arms of the shifterPull the detent lever back up to NEUTRAL position to hold the cradle and shaft in
place1n1 12Coat thrust bearing and thrust washer with OMC Needle Bearing Assembly GreasePlace the bearing on the back of
the forward gearSet the washer on top of the thrust bearingInsert the gear, bearing, and washer assembly into the bearing