1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 290Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 290

10 833096 The clutch dog is not symmetricalIf installed backward, it will not fully engage reverse gear and will immediately
pin with hole in forward end of gearcase housingr:;:;l r:;-:;l 14V6Align holes in the clutch dog with slot in the 17Lubricate
two new shift rod cover O-rings with OMC Triple-Guard greaseInstall the O-rings into the shift rod coverPlace the shift rod
grommet and shift rod spacer (TX, TZ models) on the shift rodGrease the threaded end of the shift rod and insert it through
the coverTurn the shift rod while pushing it through the cover to avoid damaging the O-rings18Apply OMC Gasket Sealing Compound
to both sides of new shift rod cover gasket Position the gasket on the gearcaseThread the shift rod into the detent lever
about four turns19Move shift rod from side to side while pushing on the propeller shaft to ensure proper alignment of the
bearing housing locator pin into the locator pin hole in the gearcaseTap the end of the propeller shaft with plastic or rawhide