1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 292Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 292

COA6192 29Models using retainer plate and retaining rings: 1241 Slide the bearing housing retainer plate into position over
the drain slot at the bottomPress the bearing housing into the gearcase and tap the housing in with soft face mallet to seat
the a-ring Apply OMC Gasket Sealing Compound to the threads of the four retaining screwsInstall two of the screws into the
bearing housing finger tightRemove the guide pins and install the other two screwsThen, tighten all four screws to torque
of 120-144 inIbs(14-16 Nm)30Models using bearing housing retainers: 12s1 Carefully apply OMC Gasket Sealing Compound to the
a-ring flange and aft support flange of the bearing housingDo not allow sealer to contact either forward thrust surface or
bearings in the housingInstall the housing in the gearcase with screw holes in vertical position and anode facing downPress
the bearing housing into the gearcase and tap the housing with soft face mallet to seat the a-ringInstall the two retainers,
washers, and screwsApply OMC Ultra Lock-271 to threads of the two retainer screwsInstall the screws and torque them to 20-24