1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 302Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 302

25If the water intake screen cannot be unplugged by cleaning, replace it: 1321 Remove screw on starboard side of gearcase
tighten the jaws securely behind the lower sealInspect bearings in placeIf bearing is removed for any reason, it must be
discardedf21 2Remove either bearing using OMC Puller Bridge, PI 432127, and OMC Large Puller Jaws, PI 432129Rest the puller
plate on top of the housing to support the bridge, and ighten the jaws securely behind the bearing 3Discard the bearing housing
O-ringClean the housing and bearings in solvent and dry thoroughlyIf bearings were not replaced, rotate the needles with
your fingers to check for freedom of movementInspect O-ring groove, and sand off any sharp edges that would cut O-ring and
prevent its sealing 4Oil, then install new bearings in the bearing housing: Use OMC Bearing Installer, PI 339750, to install