1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 303Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 303

5Install two new seals back to back in the rear of the bearing housing using OMC Seal Installer, PI 336311Apply OMC Gasket
1Remove the two driveshaft bearing housing seals using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PI 432129Discard
the seals2Remove the O-ring from the bearing housing and discard3Clean the bearing housing in solvent to remove sealer from
the seal bore and the O-ring grooveInstall new seals back to back in the bearing housing using OMC Seal Installer, PIN 330268Apply
OMC Gasket Sealing Compound to the metal casings of the seals before installingInstall the inner seal with flush lip facing
toward the bearing housing, then the outer seal with extended lip facing away from the bearing housingApply OMC Triple-Guard
grease to the seal lips after installingDR2062 Isl f61 4l.J Lightly apply OMC Triple-Guard grease to new O-ringInstall the