1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 306Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 306

5Rotate the driveshaft several revolutions to seat bearings f41 6Position the correct shim gauge against guide pins of the
the pinion with feeler gauge CDReplace the pinion or the driveshaft, as necessary, and repeat the check if variance exceeds
0.002 in (0,050 mm) 9Subtract the average clearance measurement obtained in Step from 0.030 in(0,762 mm) to determine the
correct shim thickness requiredSelect the fewest number of shims to achieve he correct thickness10Remove the driveshaft from
the tool baseRemove the collar and bearing housing from the driveshaft and add the required amount of shimsUse extreme care
when removing bearing housing to avoid damaging the sealsUse OMC Driveshaft Seal Protector, PIN 31867411Check shimming by
reassembling the driveshaft with shims and placing it back into the tool baseYour reading between the gauge bar and the pinion