1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 308Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 308

rJl 8To begin the reassembly ofthe shift mechanism, apply OMC Needle Bearing Assembly Grease to the detent ball and springInsert
Grease to the thrust bearing and thrust washerInstall the thrust bearing on shoulder of the forward gearInstall the thrust
washer on shoulder of the bearing housingPlace the forward gear into the bearing housingMake sure the thrust bearing is between
the thrust washer and forward gearrJl lNotel Bearing shown and washer must be installed exactly as 1al 14Align holes in the
clutch dog with slot in the propeller shaftInstall the clutch dog on the shaft with "PROP END" facing rear of the shaftThe
clutch dog is not symmetricalIf installed backward, it will not fully engage reverse gear and will immediately damage itself
and the gear91 15Slide the propeller shaft onto the shifter shaft and align the hole in the shaft with the hole in the clutch