1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 310Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 310

COA3130 I16l r:J7l 22Lightly apply OMC Gasket Sealin9Compound to the gearcase area that contacts mounting flange of the bearing
torque the pinion nut to 100-110 ftIbs(136-149 Nm)Overtorquing or undertorquing the pinion nut will reduce pinion lifeDo
not reuse damaged pinion nutsr,gl 27Position the washers on the driveshaft bearing housing screwsApply OMC Gasket Sealing
Compound to the threads of the screwsInstall the screws and tighten little at time to press the bearing housing down evenlyTighten
screws to torque of 168-192 inIbs(19-22 Nm)28Oil, then install the thrust bearing and large thrust washer on the hub of the
reverse gearApply OMC Needle Bearing Assembly Grease to the small thrust washer Place the small thrust washer in recess of
the reverse gearSlide the reverse gear onto the propeller shaft until it engages the pinion 221 29Carefully apply OMC Gasket
Sealing Compound to both O-ring flanges of the bearing housingDo not allow sealer to contact either forward thrust surface