1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 313Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 313

C0A3129 Insta II ation 111 1Place new O-ring on the driveshaftCoat the driveshaft splines with OMC Moly LubeDo not coat top
engages the crankshaft, the water tube enters the water pump, and the lower inner exhaust housing does not slip out of positionr:;J
Apply OMC Gasket Sealing Compound to the attaching screwsInstall and tighten the screws to the following torques: GEARCASE
RETAINING SCREWS in retaining screws inretaining screws 26-28 ftIbs(35-38 Nm) 45-50 ftIbs(61-68 Nm) 5If removed, install
the trim tab and gasket and align trim tab with the index marksTighten the screw to torque of 120-144 inIbs(14-16 Nm) ""