1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 322Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 322

21 Push the propeller shaft out of the bearing housing22Remove thrust bearing and thrust washer 1161 23Remove both seals
were not replaced, rotate needles with your fingers to check for freedom of movementInspect O-ring groove and sand off any
sharp edges that would cut O-ring and prevent its sealing r:j'71 26To replace the front bearing, lightly coat the outside
case with gearcase oilFace the lettered end of the bearing case toward the large diameter end of OMC Bearing Installer, PI
432401, and slide it onto toolPress bearing into housing until the tool seats1181 27To replace the rear bearing, lightly
coat the outside case with gearcase oilPlace lettered end of bearing case on small diameter end of bearing installer, then