1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 356Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 356

f151 14If more than half worn, remove the brush sets for replacementf16l 15Inspect locating ring on armature shaft and replace,
off any deposits of carbon or foreign matter which may contribute to later failure of the windingsr,gl 4Check permanent magnetsMagnets
should strongly attract any steel or iron object held inside the frameWeak magnets could cause excessive RPM on No Load Current
Draw, Electric Starter test5Do not clean the starter drive assembly while the starter motor and drive are installed on the
powerheadThe cleaning agent could drain into the starter motor, washing dirt from the drive into the starter bearings and
commutatorAfter disassembling the drive, clean each part with grease solvent and inspect for wear and distortion6If the pinion