1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 382Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 382

Pump and Reservoir Servicing Function Tests [!] 1Remove the rear plug from the side of the reservoir19l 2Install components
system's flow rate while the boat's steering system is disconnectedWith the engine running at 700 RPM, cycle the cylinder
from fully retracted to fully extended position by pushing on the spool valve bellcrankCycle time should not exceed 1.5 seconds7When
installing the boat's steering system, replace the locknut if you do not feel definite resistance to tighteningRemoval i
and remove all spark plug leads "" To avoid accidental starting of engine while servicing, twist r:;:;l 1Remove flywheel
nut using Snap-on A-144 fixture, or equivalent, and 1716 insocket 2Loosen upper and lower idler housing pivot screws G3l
31141 4 Loosen power steering belt rod locknuts and release tension on Remove six screws, pulley to flywheel Safety Related