1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 386Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 386

Inspection Before inspecting components, thoroughly clean them with mile aerosol solvent, and blow dry with shop air of not
hand Check the relief valve seats, balls, and guides for nicks or distortionAssembly The seal and a-rings necessary to assemble
the pump and reservoir are available in OMC a-ring Kit, PIN 985330a -rings are identified by dimensions in this assembly
procedure (I.Dx thickness in inches)1341 1If removed, install new lower shaft bearing Place the lettered end of bearing against
OMC Installing Tool, PIN 912101, and press into place1341 in(6,3 mm) spacer must be used with all CC (1988) and newer enginesCU
(1987) and older models do not require this spacer when using OMC Installer, PIN 912101 f'N=J The 14 1351 2Support the bearing
cone and press pump shaft into the upper bearing until bearing seats completely on shoulder1361 3Use No.4 external retaining