1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 387Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 387

1371 4Use plastic mallet to tap the shaft and bearing assembly into the reservoir until upper bearing seats on reservoir
7Coat two new O-rings (.795 .104" and 2.350 .140") with GM Dexron "fluid, and install in pump housing grooves1411 8Match
the alignment bushings and install the gerotor and pump housingInstall the four retaining screws and torque to 120-144 inIbs(14-16
Nm), following an "X" patternr:;:;J 9Lightly coat the lips of new shaft seal with OMC Triple-Guard greaseLightly coat the
seal 0.0with OMC Gasket Sealing CompoundPress into place until completely seated in reservoirr:;] 10Using new O-rings lubricated