1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 389Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 389

48 Installation 1481 1Place two ramp lock washers, with ramps together, on each of the three pump mounting screws1491 2Install
at 500-1000 RPM for 30 seconds6Recheck reservoir fluid level and fill as necessary1521 7Torque the dipstick to 50-60 inIbs(6-7
Nm)8Route the drive belt around the pump and idler pulleys9Clean the crankshaft and flywheel tapers with OMC Cleaning Solvent
and let air dry531 10Align the flywheel keyway and install flywheelCoat the threads of new r.e taining nut with OMC Gasket
Sealing CompoundInstall the nut and torque itto 140-150ft.lbs(190-204 Nm):54 11Install the six pulley screws and torque to
60-84 inIbs(7-9 Nm)12Adjust drive belt tensionRefer to Belt Tension Procedure, this section13Recheck reservoir fluid level