1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 417Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 417

Hydraulics Troubleshooting If the power trim and tilt system has malfunctioned and the cause has not been determined, the
in the system due to low fluidFill reservoir and bleed (purge air from) the system, as described in Routine Inspections3If
you suspect mechanical binding, open the manual release valve and manually tilt the motor up and down to test for bindingIf
parts are binding, refer to Section 5, Midsectionr:;l 4If 3- or 4-cylinder engine will not lower from shallow water drive
position at any throttle setting, or if V6 engine will not stay in shallow water drive and drops down at fast idle, the wrong
manual release valve may be installed Check for the identificat ion groove in the face of the valveThe valve in 3- and 4-cylinder
engines HAVE GROOVEThe valve in V6 engines have NO GROOVE5If your engine does not tilt as high as it should, and the tilt